Before you go for the instruction part, you may need a few tools to complete the process. You should be aware of making an informed decision to prevent fire related injuries. ![]() An electric shock is possible even when working safely and can make a fire. With this arrangement, the fan and light are turned off and on with the wall switch and the fan speeds are controlled with the builtin pull-chain on the fixture. To wire your bathroom fan and light to one switch, you must follow some instructions. The source ground is spliced through to the ceiling box and connected to the green ground wire on the fan and to any grounding terminal found there. The source neutral is spliced through to the white wire on the fan. At the ceiling location, it's spliced to the black and blue wires from the fan and light. The black wire running to the ceiling box is connected to the other terminal on the switch. Here the hot source is connected directly to the switch and 2-wire cable runs from there to the ceiling fan. Green Wire: This wire is critical as this wire saves the fan from having power swells. Simply connect the black wire with the electric motor and take out the red wire if your fan doesn’t have any lighting fixture. Connect the light/fan hot wire to one switch and the exterior light to the other. In addition, the ceiling fan should have a black, white and green wire. Your electrical wiring should include two hot wires-one black and one white-as well as a green ground wire attached to the metal electrical box. Run your supply hot wire to both switches. Before attempting to wire a ceiling fan with light from one switch, it's important to understand your electrical wiring. Remove your existing box and install the 2-gang box in its place. Use this wiring when the power source originates at the wall box and you want to control both the fan and light with a single switch. Red Wire: This wire is also the primary wire of the fan as this wire gives a separate switch for both light and fan. Get a 2-gang box to replace your existing 1-gang box. With this arrangement, power to the fan is controlled with a builtin pull-chain on the motor housing and the light is controlled with the wall switch. The red wire on the 3-wire cable is connected to the switch and at the fan, it's spliced with the blue wire to the light. Answer: To control the ceiling fan and light separately with two wall switches, a three conductor cable needs to be installed from the switch location to the. The source hot wire is spliced to the black fan wire to hardwire it directly to the circuit and to a pigtail connecting the switch. Lastly, the white wires that are coming from the fan and ceiling need to be connected together. The color of that wires are green or yellow. Ground wires need to be connected together. The source neutral and ground are spliced through to the fan location. This method will allow you to connect and operate the ceiling fan and light kit by a single switch. In this wiring, the source is at the switch and 3-wire cable runs from there to the fan and light. That can also be accomplished, but I'm not going to cover it here.Wiring a Fan and Light to a Single Switch If you want to use the remote for the light or fan, and a wall switch for the other.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |